3D printed, 62mm high Macintosh 128k replica case for the 1-bit rainbow pico-mac-nano implementation of the open source pico-mac project. High resolution FDM printed in pale beige PLA, this set comprises the front case (which incorporates the LCD and PCB supports), the rear case (with pop-out panel to support optional battery power module), the Pico reset and boot-select buttons actuator, two black hex bolts and a matching hex key. The front case comes with pre-installed brass screw inserts.
The 3D printable files are freely available on the pico-mac-nano github page if you wish to 3D print the case for yourself (personal use only - not for resale). What you are paying for here is mainly the print time which for one case set is approx 4hrs on our Bambu Labs A1.